I am trying to run the Adafruit I2S 3W Stereo Speaker Bonnet (with 3W 4ohm stereo speakers connected) with the Nvidia Nx using the I2S0 interface that is exposed on the 40 pin connector: Currently, I have the following pins connected to the Adafruit board: 2- 5V 4- 5V 6- GND 12- I2S0_SCLK (Conn…

Hello! By default the I2S pins are not enabled, but you can enable them by running the following commands … $ sudo /opt/nvidia/jetson-io/config-by-function.py -o dtb i2s5 $ sudo reboot Then you should be able to try speaker-test as follows (assuming it supports 16-bit samples @ 48kHz) … $ speake…

Running Adafruit I2S 3W Stereo Speaker Bonnet with the Nvidia Nx

Autonomous Machines Jetson & Embedded Systems Jetson Xavier NX

ocampo October 7, 2020, 5:06pm 4

Great. That worked. Thank you

Running Adafruit SPH0645 microphone with the Nvidia Nx