Running fio cause reset of the jetson-tx2i board

Hi!

I flashed jetpack 4.4 on jetson-tx2i development kit. I wanted to do some testing for the emmc, so I used fio for that. I ran fio on the following configuration file:

# The most basic form of data verification. Write the device randomly
# in 4K chunks, then read it back and verify the contents.
[write-and-verify]
rw=write
bs=8k
direct=1
zero_buffers=1
ioengine=libaio
iodepth=16
verify=crc32c
size=20G

It ran for about 5 minutes and than the board had a reset. It occurres 3 times. Any suggestions how to solve this?

hello shlomi.39sd,

you may checking your file system size, i.e. $ df -h, you’ll need available size for doing this testing.
please also setup serial console, you should gather the logs to understand why system reboots.
thanks