Running Ultimaker Cura on Jetson Nano

Hi All,

I’m trying to install ultimaker Cura 3d printing software on jetson nano. Essentially, I’m hoping to make the nano a jack of all trades computer for students to use in my classroom. When I execute the appimage after downloading the ubuntu software version, nothing happens.

Thanks!

Hi jordankivitz,

I’m not familiar with ultimaker Cura 3d printing software, thus can’t give the answer, but do you know whether the SW can support running on arm64 architecture?

I’ve been trying to do this too. The problem is the libraries in the repos are horribly old. I mean stable ;)

There is a version in the repo but it too is very old.