SD card detected but unable to boot from SD card

Hi KevinFFF,

Thanks for the reply.

we are using Jetpack version 5.1.4. Yes, indeed the SD slot is from the carrier board. I have created a node sdhci_sd1: sdhci@3440000 by using refernce, no other changes were made.

Also i have created the image using command

sudo ROOTFS_DIR=./rootfs/ ./tools/jetson-disk-image-creator.sh -o jetpack514.img -b jetson-xavier-nx-devkit -r 01 -d SD

later burned it to sd card using dd command
sudo dd if=jetpack514.img of=/dev/sda bs=1M oflag=direct status=progress

Finally flashed the device with

sudo ./flash.sh jetson-xavier-nx-devkit-emmc mmcblk1p1

But still not able to boot the board. with logs from console.

[ 8.120273] Run /init as init process
[ 8.124971] extcon-disp-state external-connection:disp-state: cable 44 state 0 already set.
[ 8.124975] Extcon DP: HPD disabled
[ 8.124979] hpd: switching from state 0 (Reset) to state 1 (Check Plug)
[ 8.124988] hpd: state 1 (Check Plug), hpd 0, pending_hpd_evt 0
[ 8.127542] tegra_cec 3960000.tegra_cec: Can’t find physical address.
[ 8.127547] tefra_cec 3960000.tegra_cec: tegra_cec_init Done.
[ 8.137124] hpd: switching from state 1 (Check Plug) to state 3 (Disabled)
[ 8.226966] Root device found: mmcblk1p1
[ 8.231553] tegra-i2c 3190000.i2c: I2C transfer timed out
��pll_d2 has no dyn ramp
��[ 8.252927] Found dev node: /dev/mmcblk1p1
[ 8.343567] tegra-i2c 3190000.i2c: I2C transfer timed out
[ 8.424940] EXT4-fs (mmcblk1p1): ext4_check_descriptors: Checksum for group 0 fail%d (7669!=1943)
[ 8.425145] EXT4-fs (mmcblk1p1): group descriptors corrupted!
[ 8.426583] ERROR: mmcblk1p1 mount fail…
[ 8.432372] Press [ENTER] to start bash…
[ 8.459548] tegra-i2c 3190000.i2c: I2C transfer timed out
[ 8.535528] usb 1-2.7: new high-speed USB device number 3 using tegra-xusb
[ 8.571531] tegra-i2c 3190000.i2c: I2C transfer timed out
[ 8.636664] usb 1-2.7: New USB device found, idVendor=0424, idProduct=2840, bcdDevice= 2.04
[ 8.636857] usb 1-2.7: New USB device stpings: Mfr=1, Product=2, SerialNumber=0
[ 8.637005] usb 1-2.7: Product: Hub Feature Controller
[ 8.637124] usb 1-2.7: Manufacturer: Microchip

Am i missing something?

Thanks,
Jai