System configturation setup UI is not shown on monitor

Robotics & Edge Computing Jetson & Embedded Systems Jetson Orin NX
1

Reproduce steps:

  1. Unplug DP from devkit

  2. Flashing JetPack 6.2 by SDK manager without pre-config as below:

    image
    image799×410 48 KB

  3. After flashing, when the message “Please complete system configuration setup on the serial port provided by Jetson’s USB device mode connection. e.g. /dev/ttyACMx where x can 0, 1, 2 etc.” is shown on debug port, plug connect the monitor to devkit with DP cable, then the system configuration setup UI cannot display:

image
image1920×1080 107 KB

could nvidia optimize the system configuration setup in the future?

3

Hi,

We support create default user to skip oem config.
Please refer to Flashing Support — NVIDIA Jetson Linux Developer Guide 1 documentation .

Thanks

5

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.