There is pinmux table in download center, you can refer to it. The POR column shows the power on reset state of each pin, it is unchangeable.
Related topics
| Topic | Replies | Views | Activity | |
|---|---|---|---|---|
| How to set TK1 pad "USB_VBUS_EN2" power on initial state from bootloader or kernel | 2 | 532 | October 18, 2021 | |
| RESET_IN & GPIO_EXP1&0_INT Boot functionality | 3 | 909 | March 31, 2016 | |
| Voltage level of GPIOs | 2 | 681 | October 18, 2021 | |
| Tegra TK1 not entering in boot mode | 4 | 525 | December 5, 2023 | |
| PWR_LED pin control | 5 | 447 | September 25, 2023 | |
| POR Pin state and requirement for no pins to have voltage applied during power on before boot | 2 | 413 | November 20, 2023 | |
| [HW] Power Sequence & Reset pins | 8 | 3009 | April 8, 2016 | |
| UART0_TX/UART0_RTS select one of four DRAM configuration sets within the BCT | 2 | 447 | October 18, 2021 | |
| jetson tx22 does not exit from reset | 5 | 548 | October 18, 2021 | |
| How to determine the IO state of the module before the power-up sequence is completed? | 3 | 27 | November 12, 2024 |