Hello,
I am trying to increase the number of USB ports to 2 on the carrier board.
I am trying to use the second port by changing the PIN assignment below, but in the source code, which assignment should I change?
<P2597_B04_Concept_schematics.pdf>
befor after
PEX_RX3_P → USB_SS1_RX_P
PEX_RX3_N → USB_SS1_RX_N
PEX_TX3_P → USB_SS1_TX_P
PEX_TX3_N → USB_SS1_TX_N
I confirmed the following Forum, but I am in trouble.
[url]https://devtalk.nvidia.com/default/topic/1046417/jetson-tx2/usb-lane-mapping-for-config-4-on-tx2-r28-2/post/5323886/#5323886[/url]