Virtual Ethernet Performance for Jetson Xavier NX

[WayneWWW]

Yes, NX supports the pcie endpoint mode. But not on NX devkit.

Jetson Xavier NX endpoint mode ODMDATA configuration

Hi all, I’m trying to configure a Jetson Xavier NX devkit in endpoint mode. I followed the instructions for the AGX, but some instructions cannot be applied “as is” since the NX is a bit different. The configuration file to be updated isn’t the p2972-0000.conf.common, but the one for the NX platform (p3668.conf.common). But, what is the value to be written to the ODMDATA to enable the C5 PCIE controller endpoint? The current value is ODMDATA=0xB8190000; Thanks.

Jetson Xavier NX endpoint mode using E3317_A01 RX/TX Swap Board

There is not ready solution available for NX. You may have to build your own.