My 2 year old got into my office and broke the USB micro-b port off my TX2 dev kit.
Anyone know where I can find a replacement carrier board? That was the USB 3.0 port for my Zed camera - and how the TX2 is flashed.
I also need this ASAP.
Any help would be appreciated!
I’ve not heard of a dev board carrier being sold separately without the module.
My attempt to repair the board failed. The traces for the USB port were just too small. Even at the lowest heat setting that would still melt solder, one of the traces flaked off.
has anyone used one of these boards from CTI?
Looking for someone to vouch that they work properly before I buy.