Why is UPHY connected in reverse in the orin dev schematic?

Hello. I’m aron,
I am checking the Orin dev circuit diagram.
Why is the UPHY order connected to m.2 key M in reverse?


Shouldn’t the ‘PER3_P’ pin be connected to ‘UPHY_RX11_P’?
Thanks.

Shouldn’t it originally be connected as shown below?
PET0_P → UPHY_TX4_P
PER0_P → UPHY_RX4_P
PET1_P → UPHY_TX5_P
PER1_P → UPHY_RX5_P
PET2_P → UPHY_TX10_P
PER2_P → UPHY_RX10_P
PET3_P → UPHY_TX11_P
PER3_P → UPHY_RX11_P

Lane reversal is supported to make the pcb layout better on devkit.

1 Like

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.