Xavier NX don`t see NVMe

user@havier-nx:~$ lspci
0004:00:00.0 PCI bridge: NVIDIA Corporation Device 1ad1 (rev a1)
0004:01:00.0 Network controller: Realtek Semiconductor Co., Ltd. Device c822
user@havier-nx:~$ lsblk
NAME MAJ:MIN RM SIZE RO TYPE MOUNTPOINT
loop0 7:0 0 16M 1 loop
mtdblock0 31:0 0 32M 0 disk
mmcblk0 179:0 0 14,7G 0 disk
├─mmcblk0p1 179:1 0 14G 0 part /
├─mmcblk0p2 179:2 0 64M 0 part
├─mmcblk0p3 179:3 0 64M 0 part
├─mmcblk0p4 179:4 0 448K 0 part
├─mmcblk0p5 179:5 0 448K 0 part
├─mmcblk0p6 179:6 0 63M 0 part
├─mmcblk0p7 179:7 0 512K 0 part
├─mmcblk0p8 179:8 0 256K 0 part
├─mmcblk0p9 179:9 0 256K 0 part
├─mmcblk0p10 179:10 0 300M 0 part
└─mmcblk0p11 179:11 0 199,1M 0 part
mmcblk0boot0 179:32 0 4M 1 disk
mmcblk0boot1 179:64 0 4M 1 disk
mmcblk0rpmb 179:96 0 4M 0 disk
zram0 252:0 0 647,1M 0 disk [SWAP]
zram1 252:1 0 647,1M 0 disk [SWAP]
zram2 252:2 0 647,1M 0 disk [SWAP]
zram3 252:3 0 647,1M 0 disk [SWAP]
zram4 252:4 0 647,1M 0 disk [SWAP]
zram5 252:5 0 647,1M 0 disk [SWAP]
user@havier-nx:~$

boot.log (39.2 KB)

Your boot log does not have useful information because the kernel log is by default in silent mode in uart.

Use command “dmesg” again and share that log.

Also, is that a NVIDIA devkit or some custom board? And is this jetson NX or AGX? This is AGX forum but your log looks like a NX.

dmesg.txt (72.8 KB)
We’re talking about the same device

dmesg in the HerrAskin post above.
We use a devkit carrier and a Jetson Xavier NX 900-83668-0000-000 processor module.

Good day! For two weeks there is no answer! We have big problems with the project! Is this such a big problem or you don’t have enough data to help us?

@big.data.lab.ru can you provide more information (datasheet) on the NVMe card?

Kingston NV1 [SNVS/250G]

Thank you. We will contact you shortly with further updates.