Kernel command line: console=ttyS0,115200 root=/dev/mmcblk0p1 rw rootwait rootfstype=ext4 console=ttyS0,115200n8 console=tty0 fbcon=map:0 net.ifnames=0 isolcpus=1-2 video=tegrafb earlycon=uart8250,mmio32,0x3100000 nvdumper_reserved=0x1772e0000 gpt rootfs.slot_suffix= tegra_fbmem=0x3a0000@0x96085000 lut_mem=0x2008@0x96081000 usbcore.old_scheme_first=1 tegraid=18.1.2.0.0 maxcpus=6 no_console_suspend boot.slot_suffix= boot.ratchetvalues=0.2031647.1 vpr_resize bl_prof_dataptr=0x10000@0x175840000 sdhci_tegra.en_boot_part_access=1 root=/dev/mmcblk0p1 rw rootwait rootfstype=ext4 console=ttyS0,115200n8 console=tty0 fbcon=map:0 net.ifnames=0 isolcpus=1-2 vddio-sdmmc1: 1800 <--> 3300 mV at 3300 mV mmc0: SDHCI controller on 3460000.sdhci [3460000.sdhci] using ADMA 64-bit with 64 bit addr mmc1: SDHCI controller on 3440000.sdhci [3440000.sdhci] using ADMA 64-bit with 64 bit addr mmc0: mmc_decode_ext_csd: CMDQ supported: depth: 31, cmdq_support: 1 mmc0: periodic cache flush enabled mmc0: new HS400 Enhanced strobe MMC card at address 0001 mmcblk0: mmc0:0001 DG4016 14.7 GiB mmcblk0boot0: mmc0:0001 DG4016 partition 1 4.00 MiB mmcblk0boot1: mmc0:0001 DG4016 partition 2 4.00 MiB mmcblk0rpmb: mmc0:0001 DG4016 partition 3 4.00 MiB mmcblk0: p1 p2 p3 p4 p5 p6 p7 p8 p9 p10 p11 p12 p13 p14 p15 p16 p17 p18 p19 p20 p21 p22 p23 p24 p25 p26 p27 p28 p29 p30 p31 p32 p33 mmc1: fallback to HS enumeration. mmc1: host does not support reading read-only switch, assuming write-enable mmc1: error -110 whilst initialising SD card mmc1: fallback to HS enumeration. mmc1: host does not support reading read-only switch, assuming write-enable mmc1: error -110 whilst initialising SD card mmc1: fallback to HS enumeration. mmc1: host does not support reading read-only switch, assuming write-enable mmc1: error -110 whilst initialising SD card mmc1: fallback to HS enumeration. mmc1: host does not support reading read-only switch, assuming write-enable mmc1: error -110 whilst initialising SD card mmcblk mmc0:0001: Card claimed for testing. Root device found: mmcblk0p1 Found dev node: /dev/mmcblk0p1 EXT4-fs (mmcblk0p1): mounted filesystem with ordered data mode. Opts: (null) Rootfs mounted over mmcblk0p1 EXT4-fs (mmcblk0p1): re-mounted. Opts: (null) vddio-sdmmc1: disabling