/*
 * Copyright (c) 2017-2018, NVIDIA CORPORATION.  All rights reserved.
 *
 * This program is free software; you can redistribute it and/or modify
 * it under the terms of the GNU General Public License as published by
 * the Free Software Foundation; either version 2 of the License, or
 * (at your option) any later version.
 *
 * This program is distributed in the hope that it will be useful, but WITHOUT
 * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
 * FITNESS FOR A PARTICULAR PURPOSE.  See the GNU General Public License for
 * more details.
 *
 * You should have received a copy of the GNU General Public License
 * along with this program.  If not, see <http://www.gnu.org/licenses/>.
 */
#include "tegra194-camera-rbpcv2-imx304.dtsi"

#define CAM1_RST_L TEGRA194_MAIN_GPIO(P, 4)
//#define CAM2_RST_L TEGRA194_MAIN_GPIO(H, 6)
//#define CAM3_RST_L TEGRA194_MAIN_GPIO(T, 6)
//#define CAM4_RST_L TEGRA194_MAIN_GPIO(T, 5)

#define CAMERA_I2C_MUX_BUS(x) (0x1E + x)

/* camera control gpio definitions */

/ {
	gpio@2200000 {
		camera-control-output-low {
			gpio-hog;
			output-low;
			gpios = <CAM1_RST_L 0>;
			label = "cam1-rst";
		};
	};

	i2c@3180000 {
		tca9548@70 {
			compatible = "nxp,pca9548";
			reg = <0x70>;
			#address-cells = <1>;
			#size-cells = <0>;
			skip_mux_detect = "yes";
			vcc-supply = <&p3509_vdd_sys_en>;
			vcc_lp = "vcc";
			force_bus_start = <CAMERA_I2C_MUX_BUS(0)>;

			i2c@0 {
				reg = <0>;
				i2c-mux,deselect-on-exit;
				#address-cells = <1>;
				#size-cells = <0>;

				imx304_a@10 {
					/* Define any required hw resources needed by driver */
					/* ie. clocks, io pins, power sources */
					clocks = <&bpmp_clks TEGRA194_CLK_EXTPERIPH1>,
							 <&bpmp_clks TEGRA194_CLK_PLLP_OUT0>;
					clock-names = "extperiph1", "pllp_grtba";
					mclk = "extperiph1";
					reset-gpios = <&tegra_main_gpio CAM1_RST_L GPIO_ACTIVE_HIGH>;
				};
			};
		};
	};
};