Welcome to minicom 2.8 OPTIONS: I18n Compiled on Jan 9 2021, 12:42:45. Port /dev/ttyUSB0, 15:27:43 Press CTRL-A Z for help on special keys [0000.126] [TegraBoot] (version 00.00.2018.01-l4t-33e7fa82) [0000.131] Processing in cold boot mode Bootloader 2 [0000.135] A02 Bootrom Patch rev = 1023 [0000.139] Power-up reason: pmc por [0000.142] No Battery Present [0000.145] pmic max77620 reset reason [0000.148] pmic max77620 NVERC : 0x40 [0000.152] RamCode = 0 [0000.154] Platform has DDR4 type RAM [0000.157] max77620 disabling SD1 Remote Sense [0000.161] Setting DDR voltage to 1125mv [0000.165] Serial Number of Pmic Max77663: 0x509e6 [0000.173] Entering ramdump check [0000.176] Get RamDumpCarveOut = 0x0 [0000.179] RamDumpCarveOut=0x0, RamDumperFlag=0xe59ff3f8 [0000.184] Last reboot was clean, booting normally! [0000.189] Sdram initialization is successful [0000.193] SecureOs Carveout Base=0x00000000ff800000 Size=0x00800000 [0000.199] Lp0 Carveout Base=0x00000000ff780000 Size=0x00001000 [0000.205] BpmpFw Carveout Base=0x00000000ff700000 Size=0x00080000 [0000.211] GSC1 Carveout Base=0x00000000ff600000 Size=0x00100000 [0000.217] GSC2 Carveout Base=0x00000000ff500000 Size=0x00100000 [0000.223] GSC4 Carveout Base=0x00000000ff400000 Size=0x00100000 [0000.228] GSC5 Carveout Base=0x00000000ff300000 Size=0x00100000 [0000.234] GSC3 Carveout Base=0x000000017f300000 Size=0x00d00000 [0000.250] RamDump Carveout Base=0x00000000ff280000 Size=0x00080000 [0000.256] Platform-DebugCarveout: 0 [0000.260] Nck Carveout Base=0x00000000ff080000 Size=0x00200000 [0000.265] Non secure mode, and RB not enabled. [0000.272] Invalid GPT Partition [0000.287] Using BFS PT to query partitions [0000.291] failed to load NvTbootTbootCpu from (2:0) [0000.296] re-load NvTbootTbootCpu from (4:0) [0000.461] Csd NumOfBlocks=250085376 [0000.520] Using GPT Primary to query partitions [0000.528] Loading Tboot-CPU binary [0000.905] Verifying TBC in OdmNonSecureSBK mode [0000.915] Bootloader load address is 0xa0000000, entry address is 0xa0000258 [0000.922] Bootloader downloaded successfully. [0000.926] Downloaded Tboot-CPU binary to 0xa0000258 [0000.931] MAX77620_GPIO5 configured [0000.935] CPU power rail is up [0000.938] CPU clock enabled [0000.941] Performing RAM repair [0000.944] Updating A64 Warmreset Address to 0xa00002e9 [0000.949] Loading NvTbootBootloaderDTB [0002.259] Verifying NvTbootBootloaderDTB in OdmNonSecureSBK mode [0002.324] Bootloader DTB Load Address: 0x83000000 [0002.329] Loading NvTbootKernelDTB [0003.638] Verifying NvTbootKernelDTB in OdmNonSecureSBK mode [0003.703] Kernel DTB Load Address: 0x83100000 [0003.711] Loading cboot binary [0005.392] Verifying EBT in OdmNonSecureSBK mode [0005.434] Bootloader load address is 0x92c00000, entry address is 0x92c00258 [0005.441] Bootloader downloaded successfully. [0005.633] Using BFS PT to query partitions [0005.637] Next binary entry address: 0x92c00258 [0005.641] BoardId: 3448 [0005.646] Overriding pmu board id with proc board id [0005.651] Display board id is not available [0007.147] Verifying SC7EntryFw in OdmNonSecureSBK mode [0007.199] /bpmp deleted [0007.201] SC7EntryFw header found loaded at 0xff700000 [0007.390] OVR2 PMIC [0007.392] Bpmp FW successfully loaded [0007.408] WB0 init successfully at 0xff780000 [0007.412] Set NvDecSticky Bits [0007.416] GSC2 address ff53fffc value c0edbbcc [0007.422] GSC MC Settings done [0007.427] TOS Image length 53680 [0007.431] Monitor size 53680 [0007.433] OS size 0 [0007.594] Secure Os AES-CMAC Verification Success! [0007.599] TOS image cipher info: plaintext [0007.603] Loading and Validation of Secure OS Successful [0007.619] SC7 Entry Firmware - 0xff700000, 0x4000 [0007.623] NvTbootPackSdramParams: start. [0007.628] NvTbootPackSdramParams: done. [0007.632] Tegraboot started after 53275 us [0007.636] Basic modules init took 5737931 us [0007.640] NvTbootQspiFlashIoctl: Opcode = 1 not supported [0007.645] Sec Bootdevice Read Time = 12 ms, Read Size = 65 KB [0007.651] Sec Bootdevice Write Time = 0 ms, Write Size = 0 KB [0007.656] Storage Device Read Time = 6731 ms, Read Size = 2306 KB [0007.662] Storage Device Write Time = 0 ms, Write Size = 0 KB [0007.668] Next stage binary read took 1527654 us [0007.672] Carveout took -1539335 us [0007.676] CPU initialization took 2036294 us [0007.680] Total time taken by TegraBoot 7762544 us [0007.685] Starting CPU & Halting co-processor 64NOTICE: BL31: v1.3(release):23b153a63 NOTICE: BL31: Built : 22:39:57, Dec 9 2019 ERROR: Error initializing runtime service trusty_fast [0007.807] RamCode = 0 [0007.811] LPDDR4 Training: Read DT: Number of tables = 2 [0007.816] EMC Training (SRC-freq: 204000; DST-freq: 1600000) [0007.829] EMC Training Successful [0007.832] 408000 not found in DVFS table [0007.839] RamCode = 0 [0007.842] DT Write: emc-table@204000 succeeded [0007.848] DT Write: emc-table@1600000 succeeded [0007.852] LPDDR4 Training: Write DT: Number of tables = 2 [0008.050] [0008.051] Debug Init done [0008.053] Marked DTB cacheable [0008.056] Bootloader DTB loaded at 0x83000000 [0008.061] Marked DTB cacheable [0008.064] Kernel DTB loaded at 0x83100000 [0008.068] DeviceTree Init done [0008.083] Pinmux applied successfully [0008.088] gicd_base: 0x50041000 [0008.091] gicc_base: 0x50042000 [0008.094] Interrupts Init done [0008.098] Using base:0x60005090 & irq:208 for tick-timer [0008.103] Using base:0x60005098 for delay-timer [0008.108] platform_init_timer: DONE [0008.111] Timer(tick) Init done [0008.115] osc freq = 38400 khz [0008.119] [0008.120] Welcome to L4T Cboot [0008.123] [0008.124] Cboot Version: 00.00.2018.01-t210-40c3ff9c [0008.129] calling constructors [0008.132] initializing heap [0008.135] initializing threads [0008.138] initializing timers [0008.141] creating bootstrap completion thread [0008.145] top of bootstrap2() [0008.148] CPU: ARM Cortex A57 [0008.151] CPU: MIDR: 0x411FD071, MPIDR: 0x80000000 [0008.156] initializing platform [0008.163] Manufacturer: MF = 0xc2, ID MSB = 0x25 [0008.168] ID LSB = 0x36, ID-CFI len = 194 bytes [0008.172] Macronix QSPI chip present [0008.176] SPI device register [0008.179] init boot device [0008.181] allocating memory for boot device(SPI) [0008.186] registering boot device [0008.195] sdmmc node status = okay [0008.198] sdcard instance = 0 [0008.201] sdcard gpio handle 0x56 [0008.205] sdcard gpio pin 0xc9 [0008.207] sdcard gpio flags 0x0 [0008.211] vmmc-supply 0x99 [0008.213] Instance: 0 [0008.215] Allocating memory for context [0008.219] enabling clock [0008.221] sd card init [0008.224] Check card present and stable [0008.227] Send command 0 [0008.244] Send command 3 [0008.248] Set RCA for the card [0008.251] Query card specific data by command 9 [0008.258] Parse CSD data [0008.260] Send command 7 [0008.270] Calling sd device register [0008.274] Init sdcard [0008.276] Allocating memory for boot device [0008.280] Registering user device [0008.293] Enable APE clock [0008.296] Un-powergate APE partition [0008.299] of_register: registering tegra_udc to of_hal [0008.304] of_register: registering inv20628-driver to of_hal [0008.310] of_register: registering ads1015-driver to of_hal [0008.316] of_register: registering lp8557-bl-driver to of_hal [0008.321] of_register: registering bq2419x_charger to of_hal [0008.327] of_register: registering bq27441_fuel_gauge to of_hal [0008.339] gpio framework initialized [0008.342] of_register: registering tca9539_gpio to of_hal [0008.347] of_register: registering tca9539_gpio to of_hal [0008.353] of_register: registering i2c_bus_driver to of_hal [0008.358] of_register: registering i2c_bus_driver to of_hal [0008.364] of_register: registering i2c_bus_driver to of_hal [0008.369] pmic framework initialized [0008.373] of_register: registering max77620_pmic to of_hal [0008.378] regulator framework initialized [0008.382] of_register: registering tps65132_bl_driver to of_hal [0008.388] initializing target [0008.394] gpio_driver_register: register 'tegra_gpio_driver' driver [0008.402] board ID = D78, board SKU = 0 [0008.406] Skipping Z3! [0008.411] fixed regulator driver initialized [0008.428] initializing OF layer [0008.431] NCK carveout not present [0008.434] Skipping dts_overrides [0008.439] of_children_init: Ops found for compatible string nvidia,tegra210-i2c [0008.455] I2C Bus Init done [0008.458] of_children_init: Ops found for compatible string nvidia,tegra210-i2c [0008.468] I2C Bus Init done [0008.471] of_children_init: Ops found for compatible string nvidia,tegra210-i2c [0008.481] I2C Bus Init done [0008.484] of_children_init: Ops found for compatible string nvidia,tegra210-i2c [0008.494] I2C Bus Init done [0008.497] of_children_init: Ops found for compatible string nvidia,tegra210-i2c [0008.507] I2C Bus Init done [0008.510] of_children_init: Ops found for compatible string maxim,max77620 [0008.520] max77620_init using irq 118 [0008.525] register 'maxim,max77620' pmic [0008.529] gpio_driver_register: register 'max77620-gpio' driver