This question was related to my other post. I had difficulties is using the UART located physically at pins B16 and B15. @JerryChang replied that the UART in pins B16 and B15 is configured to be used for wifi or bluetooth (not sure if that is going to make a difference for me to use them as serial port). From my perspective, ports /dev/ttyTHS2 works and /dev/ttyTHS1 doesn’t. So if I swap the drivers for the UARTs by using the procedure above, will I be able to use the pins B16,B15 as a serial port?
vinmeen
9
Related topics
| Topic | Replies | Views | Activity | |
|---|---|---|---|---|
| how to change uart1(tegra signal ) to drive to uart 2 module pin instead of to uart 0 module pin in tx2/i | 5 | 834 | November 29, 2019 | |
| How to use uart2 in tx2 | 5 | 1746 | June 5, 2020 | |
| TX2 UART - Enabling /dev/ttyTHS2 | 18 | 11504 | April 23, 2018 | |
| UART2 used as /dev/ttyTHS3 | 6 | 1929 | April 2, 2018 | |
| How to use UART on Tegra TX1? | 6 | 2709 | November 15, 2017 | |
| UART1 acts as default debug port on TX2, R28.1 | 14 | 11145 | February 21, 2018 | |
| UART2 configuration doubts on TX2 based custom board. | 1 | 584 | January 30, 2020 | |
| UART doesn't work | 10 | 1724 | February 28, 2019 | |
| How to use UART on TX2? | 12 | 10257 | April 23, 2018 | |
| configure uart0 to uart2 | 1 | 556 | September 18, 2019 |