I am configuring mcp2515 on R35.1 and restarting the development board after completion. Using the ifconfig command, I can see the configured can1. However, during loopback testing, I used cansend to send data, but candump did not receive it.What are the solutions available，thank you! [123] [345] …

There is no update from you for a period, assuming this is not an issue any more. Hence we are closing this topic. If need further support, please open a new one. Thanks How did you connect CAN1 TX and RX for loopback test? Have you tried to use 2 CAN transceivers and connect as the instruction …

Configuring mcp2515 on Xavier NX of version R35.1

Robotics & Edge Computing Jetson & Embedded Systems Jetson Xavier NX

Yolomei July 4, 2023, 8:09am 5

The device tree is configured as
tegra194-p3668-0001-p3509-0000.dts (1.8 KB)

Topic		Replies	Views
How to enable MCP2515 on Xavier-NX Jetson Xavier NX can-bus	18	2971	October 18, 2021
Occasional inconsistency between the sending and receiving data of the MCP2515 chip Jetson Xavier NX can-bus	15	395	March 14, 2024
Using MCP2515(SPI-to-CAN) on Xavier LOOP test works fine but can't comnicate with other CAN device Jetson AGX Xavier can-bus	7	1429	October 18, 2021
Jetson AGX Xavier Developer Kit CAN commmunication error Jetson AGX Xavier can-bus	19	2284	August 29, 2023
How to using CAN In nx devkit Jetson Xavier NX can-bus	18	11207	October 18, 2021
Mcp2515 config Jetson Xavier NX can-bus	12	789	February 24, 2023
candump not showing anything Jetson TX2	14	8370	October 18, 2021
Unable to get Jetson CAN interface to work Jetson Xavier NX can-bus , setup	12	1513	November 12, 2024
CAN Communication with Xavier NX Jetson Xavier NX boot , jetson-inference , can-bus	3	2166	October 18, 2021
Something wrong with my can test of NX? Jetson Xavier NX can-bus	16	1915	October 18, 2021

Configuring mcp2515 on Xavier NX of version R35.1

Related topics