Hello,
the cmd for fuse with --auth flag I used for testing only after I saw that I can’t flash it anymore, just to check if I can re-fuse it. For first fuse I didn’t provide it, so it was like this:
sudo ./odmfuse.sh -X fuses.xml -i 0x23 jetson-orin-nano-devkit
Jetpack release worked fine with jetson-orin-nano-devkit, I did flashing many times for this setup through SDKmanager and before fusing I also tested that I could flash Jetson from command line with the same config file.
The problem occured straight after i fused it.
Also, at this moment, when I try to re-fuse it, odmfuse.sh asks for SBKPKC keys specifically, so if I understood everything correctly, keys were written to it when I fused for first time, but after that it fails.