Hello Wayne,
I’ve successfully accessed the internet through the 10G PHY, but it seems to function only with 10G-based routers, switches, or NICs. Unfortunately, it’s not working with 1G ethernet ports or other ports. Could you please provide guidance on how to enable compatibility with all ethernet ports?
Regards,
Parashuram
Hello Wayne,
I’m sharing the ethtool log which indicates successful detection of the 10G port, but the 1G and other Ethernet ports are not functioning.
Settings for eth1:
Supported ports: [ ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
10000baseT/Full
2500baseT/Full
5000baseT/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
10000baseT/Full
2500baseT/Full
5000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Link partner advertised link modes: 100baseT/Full
1000baseT/Full
10000baseT/Full
Link partner advertised pause frame use: Symmetric Receive-only
Link partner advertised auto-negotiation: Yes
Link partner advertised FEC modes: Not reported
Speed: 10000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
MDI-X: on (auto)
Supports Wake-on: d
Wake-on: d
Current message level: 0x00000000 (0)
Link detected: yes
10g_dmesg.log (73.6 KB)
We are seeking for your help to resolve this issue, and your assistance would be greatly appreciated.
Regards,
Parashuram