On every boot of Jetson AGX Orin, the following error message is thrown up: " The current input timing is not supported by the monitor display. Please change your input timing to 1920x1080,60 hz or any other monitor listed as per the monitor specifications."

The issue is on your host PC, but not the device. Do you have nfs-server enabled on your host PC? sudo systemctl status nfs-server.service Or are they even enabled in kernel config? cat /proc/filesystems | grep nfs Also maybe check the firewall setting. If you don’t know what I’m taking ab…

Jetson AGX Orin Bootup Failed

Autonomous Machines Jetson & Embedded Systems Jetson AGX Orin

DaveYYY December 1, 2023, 5:54pm 16

Hi,

This is a typical issue on Orin series:

[   0.2617 ] Sending bct_br
[   0.2617 ] ERROR: might be timeout in USB write.
Error: Return value 3

Please refer to the solution here: