As said, it depends on your SSD device. If I2C is needed, you can mount 0ohm resistor to R110 and R111.
Related Topics
| Topic | Replies | Views | Activity | |
|---|---|---|---|---|
| Boot Jetson xavier NX using M.2 Key-M SSD | 21 | 1227 | August 22, 2022 | |
| NVIDIA Jetson Xavier NX Booting issue on Custom Carrier Board | 25 | 1276 | December 15, 2021 | |
| EEPROM not detected | 20 | 3173 | December 4, 2021 | |
| Detection issue of M.2 nvme SSD | 10 | 564 | November 22, 2023 | |
| Issues regarding Jetson Nano SOM | 24 | 414 | March 14, 2024 | |
| Board not booting up | 14 | 1933 | December 24, 2021 | |
| Jetson Xavier Carrier Board HDMI issue | 21 | 724 | November 15, 2023 | |
| M.2 nvme SSD detection issue | 40 | 8713 | May 9, 2022 | |
| How can SOM communicate with PCIe cards connected onto PCA9548A (8-channel I2C-bus switch with reset) with PCIe switch in between | 9 | 1528 | September 27, 2021 | |
| TX2-NX module pcie 0 used as SSD, the SSD could be lost | 24 | 2374 | December 1, 2021 |