Hi, I am using a Nano developmental board(one with SD card) I was trying to update MAC in config EEPROM(I2c address 0x50). I think with my code rather than updating I erased the EEPROM Now , after power cycle the board does not boot. I am getting only 1 byte 00 in boot console. Can some one he…

Someone also asked similar questions before. Please check this. [image] I2Cset, no boot Jetson Nano I’ve had a problem similar to this post I mucked around with I2Cset and I think I’ve overwritten something critical as the nano no longer boots. I followed the…

Updating EEPROM MAC address Erased it to junk values , now nano (3448)does not boot, How to Fix it

Robotics & Edge Computing Jetson Systems Jetson Nano

WayneWWW May 25, 2021, 3:14am 3

Someone also asked similar questions before. Please check this.

Topic		Replies	Views
Jatson Nano boot fail after modified MAC address in E2PROM Jetson Nano boot	5	575	April 30, 2020
The question about mac address in eeprom Jetson Nano	16	1957	December 18, 2019
After i2cset, nano can not boot and the serial port has no print information Jetson Nano boot	2	520	May 21, 2021
Jetson Nano Programming Stops Jetson Nano boot , hw , reflash , board-design	3	1270	December 3, 2020
Jetson mac adress Jetson Nano i2c	2	486	January 28, 2021
Unable to boot, EEPROM suspected to be modified Jetson Nano boot	4	652	November 21, 2022
System can not be bootable Jetson Nano board-design	1	553	June 5, 2020
after i2cset test, nano can't boot Jetson Nano	96	8734	June 4, 2020
Mac 00:00:00:00:00:01 Jetson Nano ethernet	29	6992	August 25, 2021
MAC addresses Jetson Nano	9	7374	April 3, 2020

Updating EEPROM MAC address Erased it to junk values , now nano (3448)does not boot, How to Fix it

Related topics