Cable - Jetson AGX Xavier Connector (65x11) (J3)

Robotics & Edge Computing Jetson & Embedded Systems Jetson AGX Xavier
1

Hi everyone,

I want to plug a card on the 699-pin (11x65) board-to-board connector (J3).
It should fit perfectly for a Jetson AGX Xavier module
however I have the developer kit and due to the PCIe (J6)
I am unable to plug the Xavier on the card.

Is there a cable available that could bridge the card with my Jetson Xavier Developer Kit?

2

It was just a mistake from my side while plugging the Xavier on the card.

Sorry for the noise