Can't interrupt boot from serial console

I am trying to change the boot order on the jetson nano development kit I have. I understand that it boots with uboot and therefore i need to change the boot order from serial. I have managed to visualise the serial output with a putty terminal but I can’t seem to interrupt boot with the escape key. Does someone know what I might be doing wrong ?

Probably the tx/rx of the UART pin does not connect correclty.

The cables both seem firmly on, would switching them perhaps solve the issue?

Probably… some users did such mistake before…

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.