Does Stable Diffusion run on Jetson Orin Nano?

[dusty_nv]

@seiazetsu

I searched this error and some articles tell this is caused by the version of torch and torchivision. What version are you using?

@seiazetsu I installed the stable-diffusion stuff on top of l4t-ml container, which has PyTorch installed from here:

PyTorch for Jetson

Below are pre-built PyTorch pip wheel installers for Jetson Nano, TX1/TX2, Xavier, and Orin with JetPack 4.2 and newer. Download one of the PyTorch binaries from below for your version of JetPack, and see the installation instructions to run on your Jetson. These pip wheels are built for ARM aarch64 architecture, so run these commands on your Jetson (not on a host PC). You can also use the pre-built l4t-pytorch and l4t-ml container images and Dockerfiles. PyTorch pip wheels JetPack 5

PyTo…

The PyTorch wheels from that topic were built with CUDA enabled.
I would recommend using a container for experimenting with this stuff to keep your environment clean.