HDMI to SDI conversion on Orin NX JP5.1.2

[san1998]

Hi

I want to evaluate HDMI to SDI on our custom carrier board for Orin NX p3768.
I want to configure the GS Chip - GS12170-IBE3 over SPI because we need to send the processed video in SDI format for our requirement.

Schematic:

HDMI connected to SPI -pins 89,91,93,95

I followed : Whether there is any special config to enable SPI? - #9 by wangqunpj but it did not work.

Over the GS chip i need to write certain data in the registers.

Kindly assist.
Thanks

[WayneWWW]

There is no update from you for a period, assuming this is not an issue anymore.
Hence, we are closing this topic. If need further support, please open a new one.
Thanks

Are you saying that you tried to output HDMI signal from Jetson SPI to a HDMI monitor?