How to design carrier board without Ethernet

Hello,

I am planning to make a custom carrier board without Ethernet and I am wondering if there is something special to do if that is my choice. For example, can I replace the Ethernet pins for gpio in the pinmux since I can not see it as an option. If that is not an option do I just leave the pins unconnected without any changes to the pinmux?

For those wondering, I don’t want Ethernet since this carrier board is for drones and Ethernet would add extra dead weight.

Thanks,
Daniel

Which Jetosn module you plan to use?

I plan to make a development drone that supports all the jetson nano form factor modules including orin nx.

You can just leave the pins unconnected if Ethernet is not used.

Ok, thanks

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.