Hi @JerryChang,
Thank you! The only error I could see in the log that’s relevant is the following:
[ 8.695570] rtl88x2ce 0004:01:00.0: enabling device (0000 -> 0003)
[ 8.700229] imx219 9-0010: tegracam sensor driver:imx219_v2.0.6
[ 8.710928] imx219 9-0010: imx219_board_setup: error during i2c read probe (-121)
[ 8.711288] usb 1-2.3.2: new high-speed USB device number 6 using tegra-xusb
[ 8.717046] imx219 9-0010: board setup failed
[ 8.717287] imx219: probe of 9-0010 failed with error -121
[ 8.717697] imx219 10-0010: tegracam sensor driver:imx219_v2.0.6
[ 8.719345] tegra-hda 3510000.hda: Adding to iommu group 32
[ 8.719860] tegra-hda 3510000.hda: Override SDO lines to 4
[ 8.728471] imx219 10-0010: imx219_board_setup: error during i2c read probe (-121)
[ 8.733920] imx219 10-0010: board setup failed
[ 8.734139] imx219: probe of 10-0010 failed with error -121
[ 8.753700] cpu-throttle-alert cooling device registered.
[ 8.756049] gpu-throttle-alert cooling device registered.
[ 8.756535] random: crng init done
[ 8.756672] random: 7 urandom warning(s) missed due to ratelimiting
[ 8.756758] aux-throttle-alert cooling device registered.
[ 8.757134] hot-surface-alert cooling device registered.
and I get the following output when I run cat /proc/config.gz | gunzip | grep IMX
:
# CONFIG_TOUCHSCREEN_IMX6UL_TSC is not set
# CONFIG_VIDEO_IMX214 is not set
# CONFIG_VIDEO_IMX219 is not set
# CONFIG_VIDEO_IMX258 is not set
# CONFIG_VIDEO_IMX274 is not set
# CONFIG_VIDEO_IMX290 is not set
# CONFIG_VIDEO_IMX319 is not set
# CONFIG_VIDEO_IMX355 is not set
CONFIG_NV_VIDEO_IMX185=m
# CONFIG_VIDEO_IMX477 is not set
CONFIG_NV_VIDEO_IMX219=m
CONFIG_NV_VIDEO_IMX268=m
CONFIG_NV_VIDEO_IMX274=m
CONFIG_NV_VIDEO_IMX318=m
CONFIG_NV_VIDEO_IMX390=y
# CONFIG_VIDEO_IMX204 is not set
# CONFIG_SND_SOC_IMX_AUDMUX is not set
CONFIG_USB_CHIPIDEA_IMX=m
CONFIG_PHY_FSL_IMX8MQ_USB=y
Nothing is added to the log after running the jetson-io.py
.