Jetpack 7.2 on Nano Orin - Power mode 25W and MAXN SUPER not available

Robotics & Edge Computing Jetson Systems Jetson Orin Nano
1

I installed the latest Jetpack 7.2 on a newly purchased Jetson Orin Nano. Firmware on Nano was 36.x
After the installation, the only power mode available to me is Power Mode 0 (15W).
cat /etc/nv_boot_control.conf
TNSPEC 3767-300-0005-X.1-1-1-jetson-orin-nano-devkit-
COMPATIBLE_SPEC 3767–0005–1–jetson-orin-nano-devkit-
TEGRA_BOOT_STORAGE mmcblk0
TEGRA_CHIPID 0x23
TEGRA_OTA_BOOT_DEVICE /dev/mtdblock0
TEGRA_OTA_GPT_DEVICE /dev/mtdblock0

Can anyone tell me why this is happening?

2

Hello @harryO!

Based on the title and content of your topic, it looks like it may receive better visibility and feedback in a different category. We took the liberty of moving it for you.

If this was an incorrect assessment, please send me a direct message.

Disclaimer: this moderation suggestion and message were generated with AI assistance.

3

Thanks

5

this was how i fixed it, but maybe there’s a better way: JetPack 7.2 / Jetson Linux r39.2 on Jetson Orin Nano Developer Kit — Getting Started and feedback thread - #26 by xdavxd

6

Is there any other way to do as i dont have a ubuntu laptop