Jetson nano and LoRa

[joselsm-09]

Hello everyone, I am currently trying to use an RFM95 LoRa module to communicate jetson with other devices, I enabled the SPI as mentioned in a forum, but I have not been able to make the LoRa work, I think it is because of the GPIO characteristics, if someone I have used some LoRa with jetson I would like to know, thanks.

[kayccc]

Hi joselsm-09,

I am afraid that I can not have an answer for the RFM95 LoRa module, we never tried that. hope other developers could share their experiences.

[rosvandojunior]

Hello joselsm-09,

I trying to connect a Lora Module Ra01 with Jetson Nano using SPI, but i can’t. I found out an example for RB PI 3 that do this, but with jetson nano don’t work. Do you know how to do this?

Thanks!

Best regards!

[rajaamp]

Guys,

Anyone else tried it after? please pass on if you have any good news.

[rajaamp]

Guys,

I made the LoRa communication to work with Jetson Nxavier NX, it will work for Nano as well since I am using UART communication. I used this module - RAK811 SX1276 LoRaWAN Breakout Module | LoRa SX1276 STM32 – RAKwireless Store.

I used the region US915 and ABP, it was working ok.Support is also excellent. Refer the thread RAK811 Lora does not send data for the region US915 - #9 by rajaamp - RAK811 - RAKwireless Forum to see what I did.