Hi,
I just begin with TX2 platform.
I have device which contain:
Astro Carrier (XBG001)
Astro Breakout Board (XBG201)
and Jetson TX2.
My problem is: I would like to use INA3221 external chip for my own purposes, unfortunately there are already two INA chips embedded (one on TX2 and Carrier board).
How those chips could be disabled? if they can. How this is critical? Or any solution to use additional INA3221?
For now I simple did I2C address translator which “move” INA3221 to another address, but this is not best solution.
On TX2 I can not use another I2C bus as I did on Xavier.
Regards
They cannot be disabled.
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.