hello hudc05,
please check TX2 Product Design Guide, and please refer to [Chapter-13.3 UART].
UART0 is default configure as debug header, please refer to Topic 60088 to disable that.
thanks
Related topics
| Topic | Replies | Views | Activity | |
|---|---|---|---|---|
| After the Jetson TX2 NX serial port opens UART1, it cannot be powered on after shorting RXD-TXD and CTS-RTS in RS232 mode | 4 | 739 | January 10, 2022 | |
| Device connected to ttyS0 UART causes TX2NX to not boot up | 2 | 66 | November 21, 2024 | |
| TX2: Using UART on (J21) for data exchang vs Console/debug | 16 | 347 | August 13, 2025 | |
| TX2 -- Boot/Reset hanging over bootconsole issue Confusion over UART labeling | 7 | 1548 | October 18, 2021 | |
| Inability to use ttyS0 as a regular serial communication port | 6 | 2205 | October 18, 2021 | |
| Disable serial console of u-boot on TX2 | 32 | 5906 | October 18, 2021 | |
| Jetson TX2 cannot boot when UART0 J21 is connected to a GNSS INS GPS embedded device | 5 | 1000 | October 18, 2021 | |
| NX2 TX UART on debug console port | 4 | 1533 | December 9, 2022 | |
| How to disabled Uart0's debug message? | 4 | 512 | October 18, 2021 | |
| Linux stop aboout 4 second, after console [tty0] enabled, bootconsole disabled | 4 | 2135 | October 18, 2021 |