In order to validate receive VXLAN offload, you can configure the system by using ‘ethtool’ and settingg rx-checksumming and GRO on receive side, run the traffic and observe that receive packet size is bigger than MTU using wireshark/tcpdump on receiver side.
Related topics
| Topic | Replies | Views | Activity | |
|---|---|---|---|---|
| ConnectX-3 Pro VPI/EN Receive VXLAN Offloading | 0 | 275 | June 29, 2017 | |
| ConnectX-3 Pro VXLAN Performance Overhead | 3 | 598 | June 19, 2014 | |
| Low throughput on Mellanox Connectx-4 via VXLAN tunnel | 1 | 507 | May 26, 2019 | |
| Does Mellanox Technologies MT27520 Family [ConnectX-3 Pro] supports infiniband? | 1 | 205 | December 6, 2024 | |
| VXLAN offloading not working with Mellanox/CX5 & Kernel 6.1 | 0 | 252 | September 11, 2024 | |
| Configuration of ConnectX-3 to work with Virtualbox | 2 | 315 | June 22, 2015 | |
| Ubuntu does not probe VFs on ConnectX-3 Infiniband HCA | 5 | 951 | December 11, 2018 | |
| 40Gb ConnectX-3 can only reach about 5Gbps on Jetson AGX Xavier | 9 | 1181 | June 29, 2023 | |
|
Trouble with ConnectX-3 VPI adapter card over XenServer 6.2 (Service Pack 1)
|
11 | 539 | June 3, 2014 | |
| ConnectX4-LX - Passthrough issues | 3 | 1277 | July 24, 2024 |