Jetson Nano 2g died

Hi all

Plugged the Ethernet into a Jeston Nano 2g and it stopped and never went again… any idea why?

There is no update from you for a period, assuming this is not an issue any more.
Hence we are closing this topic. If need further support, please open a new one.
Thanks

Sounds weird. How about dump the log or try to re-flash the board?

I have 7 dead Nano 4g’s so far on my project.
One of them died by typing ‘sudo reboot’.
I think there’s a systemic problem.
I tried forced recovery method on most of them. No luck.

Please file a new topic and provide info as below one tells. Especially the log from uart serial console.

https://forums.developer.nvidia.com/t/guide-for-how-to-file-a-topic-and-what-info-is-necessary-to-share/177457/2

Wow that’s a high failure rate.
Did they get replaced under warranty?

I don’t think they are all due to hardware defect. Sharing the logs may help clarify.
Maybe just some broken boot components, which could be resolved by software reset.

@mpsilcock , how about your case? Are you able to share the log?

And sorry that I notice previous link is wrong. For jetson nano, should be this link.