JP 4.4 I’m following the procedure to make a driver for an image sensor. The procedure was provided by the manufacturer, was tried before on this exact board and worked perfectly. Procedure: JetsonNanoB01_CA378_procedure.txt (3.9 KB) I seem to be able to follow without any problems until “sudo …

Please directly put the board into recovery mode and then run below command under Linux_for_Tegra on your host. sudo ./flash.sh jetson-nano-qspi-sd mmcblk0p1 And do you have other jetson nano boards on your side?

Jetson Nano B01 doesn't boot after flashing DTB

Jetson Nano B01 doesn't boot after flashing DTB