Hello,
Sorry I made a spelling mistake, the correct word should be “Xavier NX”.
When I had the screen problem, you said that the P3509 code was for the Xavier NX carrier card.
(Jetson Orin Nano Display Problem)
Based on this, I changed the DTB_FILE path to P3509.
I think there is no USB-C controller on the P3509 board, so it no longer gives the fusb301 error.
Configuration used:
BPFDTB_FILE=“tegra234-bpmp-3767-0004-3509-a02.dtb”;
DTB_FILE=“tegra234-p3767-0004-p3509-a02.dtb”;
Used Pinmux:
custom-board-gpio-default.dtsi.txt (3.5 KB)
custom-board-padvoltage-default.dtsi.txt (2.4 KB)
custom-board-pinmux.dtsi.txt (65.8 KB)
I share the hardware diagram below.
I can flash the device in Recovery mode on the carrier card without any problems.
When I connect the device to the PC with the USB-A Male cable, the “L4T-Readme” driver appears as shown below.
But when I connect a USB Mouse to the USB-A Female Socket, it does not work.
Thanks.
Thanks.