Jetson TX2 error when i rebooted

Robotics & Edge Computing Jetson Systems Jetson TX2
1

I got this error but I was unable to solve it.

Cp: not writing through dangling sgmlink 'etc/resolv.conf

3.3090051 cgroup: cgroup2: unknown opt Ion “nsdelegate” using random self ethernet address 3470S11 using random host ethernet address 3187271 using random self ethernet address

ERROR
ERROR1804×2323 718 KB

9263021 using random host ethernet address
7 .0731261 CPI-Il: shutdown

7.1253731 CPU2: shutdown

7 .3887251 vdd-1v8: voltage operat ion not allowed

7.3887331 sdhci-tegra 3440000.sdhci: could not set regulator OCR (-1)
7 .4089221 vdd-1vB: voltage operat ion not allowed u
4083351 sdhci-tegra 3440000.sdhci: could not set regulator (-1)
7 .4296481 vdd-1v8: voltage operation not allowed

7.4236581 sdhci-tegra 3440000.sdhci: could not set regulator OCR

7.4320651 vdd-1v8: voltage operation not allowed

7.4320741 sdhci-tegra 3440000 .sdhci: could not set regulator OCR

7 .5396861 vdd-1v8: voltage operation not allowed

7 .5397031 sdhci 2tegra 3440000 .sdhcl: could not set regulator OCR

7 .5406861 vdd-1v8: voltage operat ion not allowed

7 .5407011 sdhci-tegra 3440000 .sdhci: could not set regulator OCR

7 .5423111 vdd-1v8: voltage operation not allowed

7 .5423211 sdhci-tegra 3440000 .sdhci: could not set regulator OCR (-1)

7 .7777311 Bridge firewall Ing registered

3

Is this screenshot from HDMI monitor connected to TX2 or from the serial console?

Which release are you using now?

4

Yes, this is HDMI monitor which is connected to TX2 at HDMI port
TX2 is already flashed using SDKmanager- Jetpack 4.3

Actully, I was learning how to use docker on jetson and when I rebooted device, it started showing up this error.

5

Do you remember changing anything during using docker?

6

Sorry I don’t. I was just playing around with features, but I re-flashed whole device.
I appreciate your response. Thanks