Hello! Does anyone know how I can manually set Gstreamer to YES? I installed Open CV with Gstreamer support but apparently during the installation it appears to be set to YES, but in the end it is set to NO.
The problem is explained better here
GStreamer not working after i installed ultralytics
I should mention that I have a Jetson Orin nano with Jetpack 6.0 and a raspberry pi camera with an imx219 sensor.
Hello @alexandru.prisacariu
I think this Compiling OpenCV from Source wiki could be helpful for you. You can take it as a reference and try the steps in there.
Regards!
Contact us: support@ridgerun.com https://developer.ridgerun.com/ www.ridgerun.com
system
February 12, 2025, 6:57am
3
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.
