PCB Defect Classification run on Jetson Orin NX using deepstream without any output

Please provide the following information when requesting support.

• Hardware: Jetson Orin NX 16G

• Process to reproduce:
download PCB defect classification models from PCB Defect Classification | NVIDIA NGC
following the guide to install deepstream and run:
ds-tao-classifier -c pgie_multi_task_tao_config.txt -i file:///home/nvidia/pcb682.jpg
sample config pgie_multi_task_tao_config.txt (1.7 KB)

no any detection outputs in output image or command line
op17.txt (3.0 KB)

Is this correct or any thing wrong?

Have you set the correct label file? “/home/nvidia/deepstream_tao_apps/configs/multi_task_tao/label.txt” is not for this model. Please read the PCB Defect Classification | NVIDIA NGC introduction.

yes, we create this label according to the introduction

clarified, this model could only detect images which focused on one single material. Full PCB may not fit for it.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.