TLDR; I think there might be a bug in the spidev ioctl for multiple transactions. I wrote a userland application that interfaces with an IMU over SPI using spidev. Everything worked fine on the TX1 but when I tried to run the same application on the TX2 the application didn’t run. I attached a lo…

spidev behavior is different from TX2 and TX1 when using ioctl

ShaneCCC December 12, 2017, 6:08am 2

Thanks for your report. We need time to clarify it.

Topic		Replies	Views
Spidev crashes when SPI_IOC_MESSAGE(N), N > 1 Jetson Xavier NX spi , board-design	7	2394	February 23, 2023
TX1 SPI Hardware CS incorrect behavior using regmap Jetson TX1	5	823	October 18, 2021
SPI Slave Select error on Jetson TX2 J21 header Jetson TX2	0	507	November 28, 2018
TX1 L4T R28.1 spidev slave performance Jetson TX1	8	1232	January 11, 2018
Did anybody get SPI interface working on TX1? Jetson TX1	37	12128	October 18, 2021
TX1 in SPI Slave mode to an ADC. Jetson TX1	23	5729	October 18, 2021
Extra clock transition when using SPIDEV with longer transactions Jetson Xavier NX spi	6	1215	February 17, 2023
SPI Issue - 100€ reward Jetson TX1	3	638	March 6, 2018
TX2 R28.2 SPI CS-GPIO issue Jetson TX2	2	1453	October 18, 2021
TX2 SPI Half Duplex Transfers Broken Jetson TX2	2	836	October 18, 2021