The jetson nano u-boot failed to flush. The image address and memory running address were both changed to 0x84000000

[chongzi]

I clearly make menuconfig, changed the address to the same, compiled, but when tftp to the board go 0x84000000 still can’t enter the u-boot normally, still stuck in DRAM, you can see pictures

[kayccc]

There is no update from you for a period, assuming this is not an issue any more.
Hence we are closing this topic. If need further support, please open a new one.
Thanks

Sorry for the late response, have you managed to get issue resolved or still need the support? Thanks