Hello! I’m designing a carrier board for TX2NX and I was wondering about USB ports. I want to have a single USB port that can be used as a recovery port but when it boots up, it becomes normal USB port. I couldn’t exactly find any references to it. Is it possible to configure USB port like that?

You’re looking for the “on-the-go” (“OTG”) specification (the specification is from USB.org ). Basically you need to have a connector with a “detect” pin to know if the mating connector is “type-A” (for host mode when someone plugs in a device) or if it is “type-B” (for device mode, when someone trea…

TX2NX - How to use USB port for both recovery and host?

Robotics & Edge Computing Jetson & Embedded Systems Jetson TX2

Trumany December 1, 2021, 1:47am 5

You can refer to this topic for host mode on the port.

1 Like

Topic		Replies	Views
TX2 NX - How to enable USB host mode for USB0 (USB2.0 Port 0) Jetson TX2 usb , board-design	4	894	April 12, 2023
Use USB2-0 port as host port for keyboard mouse Jetson Xavier NX	3	1323	October 18, 2021
USB2 host mode (via USB OTG cable) Jetson TK1	11	6751	December 24, 2015
Force USB-OTG to Host Mode on Jetson TX1 Jetson TX1	6	1324	September 13, 2018
Tx2 not shown as usb device on host PC Jetson TX2 usb	2	551	January 14, 2022
USB OTG functionality in jetson-tk1 Jetson TK1	2	2517	September 1, 2015
Application use of USB0 vs forced recovery Jetson TX2	7	782	November 7, 2019
About TX1 mini usb port with OTG Host mode Jetson TX1	10	809	October 18, 2021
How can I change USB2. 0 port 0 to host mode, on AGX Xavier Jetson AGX Xavier usb	4	507	October 18, 2021
Jetson TX2 NX L4T 32.7.1 USB2.0 host mode is not working Jetson TX2 usb	6	675	April 19, 2022

TX2NX - How to use USB port for both recovery and host?

Related topics