Unable to use torchvision and ultralytics together on jetson-nano

[DavidDDD]

Hi,

Please refer to this topic first.

Install PyTorch with Python 3.8 on Jetpack 4.4.1

Hi @patrick.nagelm8t1h, I haven’t build PyTorch for Python 3.8 myself, so some folks from the community may have more suggestions - have you tried building a specific version of PyTorch as opposed to PyTorch master? i.e. changing your git clone command to git clone --recursive --branch v1.7.0 http://github.com/pytorch/pytorch @jonathan.boisclair was recently able to build PyTorch 1.7 for Python 3.8 on 20.04, but on 18.04 I don’t think you would need the additional patch that they did: htt…

Also refer to this topic Build from Source section

PyTorch for Jetson

Below are pre-built PyTorch pip wheel installers for Jetson Nano, TX1/TX2, Xavier, and Orin with JetPack 4.2 and newer. Download one of the PyTorch binaries from below for your version of JetPack, and see the installation instructions to run on your Jetson. These pip wheels are built for ARM aarch64 architecture, so run these commands on your Jetson (not on a host PC). You can also use the containers from jetson-containers. PyTorch pip wheels JetPack 6

PyTorch v2.3.0

JetPack 6.0 (L4T R36.2…

Thanks