We are developing a new motherboard for the Jetson Orin NX and Jetson Orin Nano. Looking at the reference design the USB switch in the recovery circuit is EOL on P3768-A04. Are there any issues with replacing this circuitry with something like the PI5USB31213 family. Obviously the I2C addressing is different for a start. Will this cause issues during recovery/flashing?
Trumany
3
You can make custom design referring to devkit and make changes in driver accordingly.
Related topics
| Topic | Replies | Views | Activity | |
|---|---|---|---|---|
| Replace FUSB301TMX by FUSB303TMX | 3 | 542 | January 25, 2024 | |
| USB0 Flashing in Recovery Mode Failure | 12 | 241 | December 16, 2025 | |
| Will USB0 be enough for recovery/flashing | 3 | 478 | September 8, 2023 | |
| Custom Carrier Board, wrong usb wiring, try to change device tree for fixing the issue | 7 | 626 | October 23, 2023 | |
| Jetson AGX Orin: Support for Recovery Mode via USB Hub on USB3_N/P Interface | 2 | 101 | February 25, 2026 | |
| Recovery Port not working after flashing custom board with pinmux changes | 6 | 521 | March 12, 2024 | |
| Jetson Orin Blank Board setup | 3 | 157 | November 29, 2024 | |
| Orin Nano Recovery USB port Needs USB3? | 1 | 84 | April 27, 2026 | |
| Regarding USB operation settings on Jetson Nano custom board | 5 | 168 | April 1, 2025 | |
| Jetson Orin Nx USB 3.2 (help understanding the pinout for the extra SS USBs) | 11 | 2000 | July 5, 2022 |