Hey, I’ve just finished adding support for a USB3 Genicam camera using Aravis for control and capture, and have run into some lovely kernel warnings. Capture from the camera seems fine, at each of 640x480, 720p and 1080p, all running at 30fps, although every now and then I seem to lose a frame or t…

Hi, There is a similar that hits bandwidth limit: [image] xhci-tegra 3530000.xhci: WARN Event TRB for slot 2 ep 6 with no TDs queued? Jetson TX2 i have my custom carrier board ,which design for three usb 3.0. three usb3.0 design for three cameras. i have three cameras …

USB3 Genicam Camera tegra-xusb xhci WARNING

Autonomous Machines Jetson & Embedded Systems Jetson TX2

DaneLLL April 21, 2020, 3:51am 3

Hi,
There is a similar that hits bandwidth limit:

Probably there is burst data coming from the camera, triggering the error.

For further investigation, you may refer to