4 lane mipi camera

Hi,

We would like to use TX2 to stream from our camera, that uses 4 lane mipi. We are confused on writing the dtsi file, especially
csi-port, bus-width, num_lanes and tegra_sinterface. Can you please help us in getting the correct value for these parameters?

Our carrier board is connected to csi port a and d. How can we set the b]tegra_sinterface[/b]?

Thanks,

hello tharunprasanth,

please check the [Sensor Driver Programming Guide] from the [L4T Documentation],
you may also refer to [V4L2 Sensor Driver Development Tutorial] from Tutorials page.
thanks