Hi Sir,
When we bring-up our customized carrier board, we have the message “Please complete system configuration setup on the serial port …” in the end of debug console.
According to the information @ NV forum, I connect another UART trying to finish system setup. Luckily, I have the screen as below,
Jetson System firmware version 36.4.3-gcid-38968081 date 2025-01-08T01:18:20+00:
00
ESC to enter Setup.
F11 to enter Boot Manager Menu.
Enter to continue boot.
(In fact, all the four console can enter system setup menu)
The question is, what should I configure to skip my HDMI & let console to show login prompt ? I just need the console to work & display login prompt, so that I can issue commands debugging under Linux.
But I browser the options and have no clues about which options to enable or disable.
Please advise. Thanks.
Jimmy