Please complete system configuration setup

Robotics & Edge Computing Jetson & Embedded Systems Jetson Xavier NX
,
1

Hello,

I have flashed linux kernel version 4.9 (L4T 32.4.4) Ubuntu 18.04 , in my Jetson NX SOM module carrier board. , and i taking logs and trying to access console by MicroUSB slot.

but i am getting this log and could not access the console.

[ 0.000000] bootconsole [tegra_comb_uart0] enabled
[ 1.979412] imx219 9-0010: imx219_board_setup: error during i2c read probe (-121)
[ 1.979623] imx219 9-0010: board setup failed
[ 2.003700] imx219 10-0010: imx219_board_setup: error during i2c read probe (-121)
[ 2.003964] imx219 10-0010: board setup failed
▒▒WARNING: at platform/drivers/pg/pg-gpu-t194.c:185
WARNING: at platform/drivers/pg/pg-gpu-t194.c:185
▒▒[ 4.781263] cgroup: cgroup2: unknown option “nsdelegate”
[ 6.043800] using random self ethernet address
[ 6.043937] using random host ethernet address
[ 6.303430] random: crng init done
[ 6.303553] random: 7 urandom warning(s) missed due to ratelimiting
[ 6.711573] using random self ethernet address
[ 6.711709] using random host ethernet address
[ 12.194285] Please complete system configuration setup on the serial port provided by Jetson’s USB device mode connection. e.g. /dev/ttyACMx where x can 0, 1, 2 etc.

Please help me in resolving the issue.

3

hello vinay2010singh,

did you setup a display monitor to output through the HDMI?
you should see the ubuntu desktop pop-up for the default system configurations.
thanks

4

Hello @JerryChang

Thanks you for replying.

No neither i am getting Console Nor Display…

My priority is getting console access first. Please help

5

hello vinay2010singh,

it by default taking display for initial configurations,
suggest you could refer to oem-config to setup it.
thanks