Wasn’t this addressed in CAN Interface not behaving right on AGX - #22 by rborad with correct CAN-High (CAN+)/CAN-Low (CAN-) pins connected?
Is there any way to reproduce the issue with Extended Message ID without the specific IMU?
Related topics
| Topic | Replies | Views | Activity | |
|---|---|---|---|---|
| CAN Interface not behaving right on AGX | 23 | 3809 | October 12, 2021 | |
| Enable CAN on Xavier | 41 | 14481 | October 13, 2021 | |
| Xavier is not communicating with another device via canbus interface | 16 | 2241 | October 18, 2021 | |
| Confusion about CAN communication for Jetson AGX Xavier | 6 | 845 | October 18, 2021 | |
| Jetson AGX Xavier, something wrong when testing CAN in normal mode( non-loopback ) | 51 | 4081 | November 10, 2021 | |
| how to enable and test CAN on Xavier | 10 | 1080 | December 12, 2019 | |
| CAN bus inconsistent behavior on L4T 32.4.4 and L4T 32.5.0 | 27 | 3042 | October 18, 2021 | |
| CANBUS not working | 10 | 192 | September 2, 2024 | |
| Probable reasons for CAN bus not getting read by Xavier | 10 | 2047 | October 18, 2021 | |
| socketcan interface can1 not work after setup aurixcan on DRIVE PX2 | 19 | 1446 | March 4, 2019 |