Getting extra PWM pins on jetson nano

[rahulbeingrahul]

I need 3 PWM pins to connect three DM542E stepper motor drivers to my jetson nano board. There are only two PWM pins available. How can I configure my GPIO pins to get another PWM pin? Also, there is an additional PWM pin on the 4-pin fan header, is there a way I can use it for the same? I won’t need to connect a fan.

[DaveYYY]

Are you guys colleague?

Jetson Nano GPIO - RMCS1120 Stepper motor driver

I’m having a hard time determining which GPIO pins must be connected to the stepper motor driver RMCS1120. I need assistance in determining which specific GPIO pins on the Jetson Nano should be used to connect the PUL+, PUL-, DIR+, DIR-, ENA+, and ENA- pins of the RMCS1120 stepper motor driver. I had a look at the specifications for the RMCS1120 stepper motor driver, but I’m unable to figure this out. Kindly please help.