We have one script that using some configuration burn and then flash our xavier-nx devices. We found that if immediately after burn we do flash; (that is device is in same force recovery mode that was burnt) our device got an issue that I report in another post. After burn and flash and enabling se…

The jumper is not needed, and should not remain connected, once in recovery mode. That jumper is like the shift key on a keyboard when trying to type a capital letter: Hold the button down, tap the button to be modified, and then let go. Recovery mode modifies either power on or power reset. If that…

How to reboot to force recovery mode when we are in force recovery mode

Robotics & Edge Computing Jetson & Embedded Systems Jetson Xavier NX

JerryChang December 13, 2024, 1:51am 8

hello Sralavi,

we usually press the hardware keys (forced-recovery+reboot) every time for image flashing.
hence, it’s suggested to follow Topic 315436, comment #24 to workaround by disabling asdp node.

Topic		Replies	Views
Flashing TX2 fails after entering recovery via forced-recovery Jetson TX2 reflash	5	538	October 18, 2021
Flashing board after reading info or any action while in recovery mode, hangs the target Jetson Xavier NX reflash	2	58	December 31, 2024
Jetson Xavier NX unable to boot after flashing Jetson Xavier NX reflash	22	3416	March 23, 2022
Force recovery mode sequence changed (L4T 32.4.3)? Jetson TX2 reflash	12	1654	October 18, 2021
Flashing AGX without being in RCM Jetson AGX Xavier reflash	2	370	October 18, 2021
Jetson Xavier NX stuck in force recovery mode Jetson Xavier NX reflash	7	1873	October 19, 2022
Enter to Force Recovery Mode without flashing the TX2? Jetson TX2	3	2019	October 18, 2021
Jetson AGX Industrial - Force_recover Jetson AGX Xavier usb	2	341	December 29, 2021
ABOUT the force recovery mode Jetson TX1	10	5494	October 18, 2021
Force reflash of Jetson without putting into recovery Jetson TX2	4	886	October 18, 2021

How to reboot to force recovery mode when we are in force recovery mode

Related topics